Sep 10, 2011

Winston Gets a New Oil Filter!


The picture above is of the type of oil filter that the 1932 Plymouth was originally equipped with.  It was the first year that oil filters were standard equipment on the Plymouth.  The whole canister is disposable.  There are brass pipe fittings that go in both the upper and lower ends of the filter.  These attach to steel tubes that attach to a supply point and a discharge point on the engine's oil system.  And the whole thing was held in a clamp on the driver's side of the engine.  When I bought the car 49 years ago, these filters were readily available and cost a couple of dollars.

The last time I was able to buy one in a car parts store was about ten years ago.  Wix still listed the filter in their catalog at a cost of about $26.00!  I bought one and then they were gone.  I started buying them on eBay, but the price kept escalating.  You have to change the filter every 1,000 miles, so even if you don't drive the car a lot it can still add up.


Last year, I read the following ad in the Plymouth Bulletin, the magazine published by the Plymouth Owners Club:

"Oil Filter: Cast aluminum, replaces the old tin throwaway type that has a 1/8" NPT fitting at each end.   4-1/4 diameter 6" long; unscrews to replace neon filter inside;will work with any engine that filters just the bypassed oil.  $165 plus shipping.  Joe McGinnis, 234 Deer Foot Road, Blairsville, GA 30512, Tel: (706) 781-2805, email callent.beefalo@hotmail.com"

  Now, Winston sports a brand new filter with the same old appearance.  What a concept!


4 comments:

Anonymous said...

How do I get one of these filters Dondytn@yahoo.com Thanx have the same car

Jeff said...

Hello .. How do I purchase one of these new spun aluminum filter housings ? Thanks jeff

Jeff said...
This comment has been removed by a blog administrator.
Bob said...

I've added the entire ad to the blog entry, including the makers name, address, phone, and email. I hope you get the filter you need.